Tricity Bendix HH352W Manual do Utilizador descarregar pdf (Página 6)

6

ELECTRICAL CONNECTIONS

Fig.1

Electrical connection Supply system

123 45

Single Phase

LN

Note: This appliance must be connected to a separate 30 AMP switch outlet.

WARNING: THIS APPLIANCE MUST BE

EARTHED.

The manufacturer declines any

liability should this safety measure

not be observed.

Ensure that the electric circuit is

capable of carrying the load of the

appliance.

Switch OFF the electricity supplies at

the mains.

A double pole cooker control switch with

a suitable electrical rating should be

used to control the electrical supply to

the hob.

The control switch should be easily

accessible to the user on completion of

the installation.

The control switch must not break the

yellow/green earth wire at any point.

To wire the hob, carefully place the unit,

face downward on a flat surface with the

control area overhanging, to avoid damage

to the controls. Remove the screws securing

the cover to the terminal box, remove the

cover and connect the supply cable via the

cable clamp (Fig.1), to the terminals

provided. The supply cable should be 6mm

2

or its equivalent.

• Connect the earth wire to the terminal

marked with the letter "E" or with the

earth symbol or coloured green.

• Connect the live wire to the terminal

marked with the letter "L" and coloured

brown or red.

• Connect the neutral wire to the terminal

marked with the letter "N" and coloured

blue or black.

• Tighten the terminal screws and the

cable clamp, then refit the terminal plate

cover. You must ensure that the cabinet is

stable and level.

This appliance complies with EEC Directive

number 76/889 and amendment 82/499 relating

to the suppression of radio and TV

interference.

Rating plate

The rating plate is situated on the

underside of the unit and gives the

type and serial number as well as the

model description of the appliance

(which should be quoted in any

communication).

Important:

The appliance must be connected to a

cooker point, having a double pole

isolating switch with a contact

separation of at least 3mm in all

poles.

1 2 3 4 5 6 7 8 9 10 11 12

Comentários a estes Manuais

Sem comentários